Looks like I am missing something in my test setup.
I have tried gplpv_fre_wnet_x86_0.10.0.69.msi. But with these drivers I
am not even seeing a hot plug event in Windows GOS when I run the xm
scsi-attach in Dom0. With the WinGPLPV-0.9.x, I used to get a hot plug event in
Do I need start any specific component/module in Xen, before hot plugging?
I tried this with a Xen 3.3.1 and with fresh Windows GOS image which didn’t
had any preinstalled GPL drivers.
From: James Harper [mailto:james.harper@xxxxxxxxxxxxxxxx]
Sent: Wednesday, July 01, 2009 6:42 PM
To: Velayudhan, Vinu; Xen-users@xxxxxxxxxxxxxxxxxxx
Subject: RE: [Xen-users] Hotplugging SCSI device to Windows 2k3 GOS
> I am trying to do a scsi hotplug to a Windows GOS using the xm
> This is my configuration
> RHEL 5.2 DOM0 with Xen 3.3
> 32 bit Windows 2k3 GOS with WindowsXenPV-0.9.4 installed. boot.ini
Try using the 0.10.x series of GPLPV drivers. You'll need to run the
uninstall script before installing.
I just tested then and it worked fine under 0.10.x. 0.9.4 may only
support the pre-release version of pvscsi that never made it into xen.