[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-devel] adding more than one disk.

  • To: xen-devel@xxxxxxxxxxxxxxxxxxxxx
  • From: "Ronald G. Minnich" <rminnich@xxxxxxxx>
  • Date: Wed, 16 Feb 2005 21:00:17 -0700 (MST)
  • Delivery-date: Thu, 17 Feb 2005 04:01:26 +0000
  • List-id: List for Xen developers <xen-devel.lists.sourceforge.net>

If I set up my xen file as follows:
disk = [ 'phy:loop0,loop0,w', 'phy:loop1,loop1,w']

I realize I should USTL but it seemed to me I should expect blkif changed 
messages for each vbd. I'm only getting the messages once. 

i.e. I see this:
===========> blkif_status_change to 1
===========> blkif_status_change to 2
===========> evtchn for blkif is 3
====> enable disk interrupt
=========> controller connected

For the first disk, and that's it. Shouldn't I see two of these sets of 
messages, one for each disk? 

Is my expectation wrong or is something else going on that I missed?


p.s. I actually now have two plan 9/xen users out there ... 2 more than I 
had a month ago. So a month ago there was one, now 3 ... at this rate we 
should take over the planet in no time.

SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.