Re: [Xen-users] Bond question

[Donny Brooks <dbrooks@xxxxxxxxxxxxxxxx>]

On 2/16/2011 3:45 PM, Paras pradhan wrote:
> Other two bonds are on the same switches. They seems to be fine..
>
> Paras.
> On Wed, Feb 16, 2011 at 3:40 PM, Donny Brooks<dbrooks@xxxxxxxxxxxxxxxx>  wrote:
> > On 2/16/2011 3:31 PM, Paras pradhan wrote:
> > > Hi,
> > >
> > > I have several nics (1Gbps) in my server running xen 3 by Redhat.
> > >
> > > When I check /proc/net/bonding/pbond0 , i see it is running in 100mbps
> > > only.
> > >
> > > --
> > > Ethernet Channel Bonding Driver: v3.4.0-1 (October 7, 2008)
> > >
> > > Bonding Mode: fault-tolerance (active-backup)
> > > Primary Slave: None
> > > Currently Active Slave: eth6
> > > MII Status: up
> > > MII Polling Interval (ms): 100
> > > Up Delay (ms): 0
> > > Down Delay (ms): 0
> > >
> > > Slave Interface: eth6
> > > MII Status: up
> > > Speed: 100 Mbps
> > > Duplex: full
> > > Link Failure Count: 0
> > > Permanent HW addr: 00:26:b9:66:2f:43
> > >
> > > Slave Interface: eth7
> > > MII Status: up
> > > Speed: 100 Mbps
> > > Duplex: full
> > > Link Failure Count: 0
> > > Permanent HW addr: 00:26:b9:66:2f:45
> > > ---
> > >
> > > Is this normal?
> > >
> > > I have other two bonds as well. They are fine and running in 1Gbps speed.
> > >
> > > What went wrong with the 1st bond?
> > >
> > >
> > > Thanks!
> > > Paras.
> > >
> > > _______________________________________________
> > > Xen-users mailing list
> > > Xen-users@xxxxxxxxxxxxxxxxxxx
> > > http://lists.xensource.com/xen-users
> > Depending on your switch you may need to force the speed option. I had to in
> > my Cisco 4507R.
> >
> > _______________________________________________
> > Xen-users mailing list
> > Xen-users@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/xen-users
Possible driver issues then? What os? Are all the same?

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users