[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] x86/apic: fix disabling LVT0 in disconnect_bsp_APIC



On 17.01.2020 17:08, Roger Pau Monné wrote:
> On Fri, Jan 17, 2020 at 04:56:00PM +0100, Jan Beulich wrote:
>> On 17.01.2020 16:09, Roger Pau Monne wrote:
>>> The Intel SDM states:
>>>
>>> "When an illegal vector value (0 to 15) is written to a LVT entry and
>>> the delivery mode is Fixed (bits 8-11 equal 0), the APIC may signal an
>>> illegal vector error, without regard to whether the mask bit is set or
>>> whether an interrupt is actually seen on the input."
>>>
>>> And that's exactly what's currently done in disconnect_bsp_APIC when
>>> virt_wire_setup is true and LVT LINT0 is being masked. By writing only
>>> APIC_LVT_MASKED Xen is actually setting the vector to 0 and the
>>> delivery mode to Fixed (0), and hence it triggers an APIC error even
>>> when the LVT entry is masked.
>>
>> But there are many more instances where we (have a risk to) do so,
>> most notably in clear_local_APIC(). The two step logic there is
>> anyway somewhat in conflict with the citation above.
> 
> clear_local_APIC masks the error vector before doing any write, and
> clears ESR afterwards, there's a comment at the top:
> 
> "Masking an LVT entry on a P6 can trigger a local APIC error
> if the vector is zero. Mask LVTERR first to prevent this."
> 
> We could do the same (ie: mask LVTERR first and clear ESR afterwards)
> if that seems preferable. There's a maxlvt check in clear_local_APIC,
> but the sdm doesn't specify anyway to check if the lapic will accept a
> masked vector 0 write or not, so not sure whether we should replicate
> that check or just do it unconditionally on both disconnect_bsp_APIC
> and clear_local_APIC.

I think doing it the most careful way is going to be best. I find it
surprising anyway that disconnect_bsp_APIC() doesn't write LVTERR
(or other LVTs except for LVT1) at all. The function looks to have a
goal of putting the APIC back into the state that we found it when
booting.

Jan

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.