Re: [Xen-devel] [PATCH 2/4] xenbus: limit when state is forced to closed

[Roger Pau Monné <roger.pau@xxxxxxxxxx>]

On Thu, Dec 05, 2019 at 02:01:21PM +0000, Paul Durrant wrote:
> Only force state to closed in the case when the toolstack may need to
> clean up. This can be detected by checking whether the state in xenstore
> has been set to closing prior to device removal.

I'm not sure I see the point of this, I would expect that a failure to
probe or the removal of the device would leave the xenbus state as
closed, which is consistent with the actual driver state.

Can you explain what's the benefit of leaving a device without a
driver in such unknown state?

Thanks, Roger.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel