Re: [Xen-devel] can't boot into dom0 - followup

[Mike Wright <mike.wright@xxxxxxxxxxxxxx>]

On 06/20/2011 06:15 AM, Konrad Rzeszutek Wilk wrote:
> On Sat, Jun 18, 2011 at 01:00:22PM -0700, Mike Wright wrote:
> > On 06/17/2011 02:13 PM, Mike Wright wrote:
> > > Hi all,
> > >
> > > New to this list.
> > >
> > > I built xen-4.1.1 successfully and can see that it boots from grub with
> > > the kernel /xen.gz line.
> > >
> > > I'm using the following kernel (3.0.0-rc2):
> > >
> > > http://git.kernel.org/?p=linux/kernel/git/konrad/xen.git and its default
> > > .config file,
> You might want to refresh it (this is #master tree and #next-3.0).
Will try that next

> > > which also builds successfully and boots standalone.
> > >
> > > When I try to boot it as a dom0 I get a segfault.
> what was the segfault?
Can't tell, scrolls off screen.  Currnently trying to figure out how to 
capture the serial output.
> > I added vga=ask,keep to the kernel /xen.gz line and chose 363 for
> > the mode, and *it boots*.
> >
> > When using runlevel 3 it seems to perform as if it were bare metal;
> > however, runlevel 5 runs extremely slow, desktop fonts don't render
> > but application fonts do.
> Hm, what is the graphic adapter you have?
Built-in:
VGA compatible controller: ATI Technologies Inc RS880 [Radeon HD 4290]

> > It took about 5 minutes to load Thunderbird so I could send this email.
> Yikes!
> > So it does seem to be vga related.
> Were there zillions of WARN in your serial console/ /var/log/messages
> when Xorg was starting?
Xorg.log.0 showed no errors at all

> > Thanks, all,
> > Mike Wright
> >
> > _______________________________________________
> > Xen-devel mailing list
> > Xen-devel@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/xen-devel
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel