RE: [Xen-devel] Another GPLPV pre-release 0.9.11-pre7

["James Harper" <james.harper@xxxxxxxxxxxxxxxx>]

> rebuild a backup of the vm for a new fresh start.
> -installation -waiting short of the end 20 minutes - rebooting manual
> ignoring the last step of the installation
> -rebooting, finding lots of devices, pressing a lot of "yes", all
devices
> show "cannot start error 10", assuming the missing gplpv flag.
> -rebooting again, all runs fine but yellow "!" on a lot of xen
devices.
> -rebooting with gplpv, resulting in bsod as mentioned below
> -rebooting without flag, runs again.
> 
> Is this a known error ?

I haven't tried an install from scratch in the last couple of versions,
but no, I don't know about that error.

What platform are you running on? Please specify hypervisor, dom0 and
domU if they are 32 or 64 bits.

Thanks

James

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel