AW: [Xen-devel] Problem with vif - help!!!!

[DIEDERIT@xxxxxxxxxxxxxxxxxxxxxxxxxxxx]

I get this:

[root@ingpcxen002 mercurial-0.7]# brctl show | cut -f 2
bridge id


[root@ingpcxen002 mercurial-0.7]# brctl show | cut -f 1
bridge name
xenbr0

[root@ingpcxen002 mercurial-0.7]#



Thomas Diederich

**************************************************
*  Boehringer Ingelheim Pharma GmbH & Co.KG
*  A Informationsverarbeitung / Diplomant Systemtechnik
*
*  Mail: diederit@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
*  Phone: +49 (0)6132/77-98151  


-----Ursprüngliche Nachricht-----
Von: Ewan Mellor [mailto:ewan@xxxxxxxxxxxxx] 
Gesendet: Donnerstag, 24. November 2005 13:21
An: DIEDERIT@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
Cc: xen-devel@xxxxxxxxxxxxxxxxxxx
Betreff: Re: [Xen-devel] Problem with vif - help!!!!


On Thu, Nov 24, 2005 at 01:09:52PM +0100,
DIEDERIT@xxxxxxxxxxxxxxxxxxxxxxxxxxxx wrote:

> 
> brctl show offers me this result:
> [root@ingpcxen002 ~]# brctl show
> bridge name     bridge id               STP enabled     interfaces
> xenbr0          8000.feffffffffff       no              vif0.0
>                                                         peth0

Well there's nothing wrong with that at all.  vif-bridge does this:

brctl show | cut -d "
" -f 2 | cut -f 1

to get the bridge name, which should succeed, but it is complaining that
this
is returning nothing.  Perhaps you could figure out why this command is not
working.  Otherwise, I'm stuck I'm afraid.

Ewan.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel