Re: [PATCH 1/2] xen/arm: Convert runstate address during hypcall

[Bertrand Marquis <Bertrand.Marquis@xxxxxxx>]

> On 13 Jun 2020, at 01:24, Stefano Stabellini <sstabellini@xxxxxxxxxx> wrote:
> 
> On Fri, 12 Jun 2020, Bertrand Marquis wrote:
>>> On 12 Jun 2020, at 02:09, Stefano Stabellini <sstabellini@xxxxxxxxxx> wrote:
>>> 
>>> On Thu, 11 Jun 2020, Julien Grall wrote:
>>>> Hi Stefano,
>>>> 
>>>> On 11/06/2020 19:50, Stefano Stabellini wrote:
>>>>> On Thu, 11 Jun 2020, Julien Grall wrote:
>>>>>>>> +        return -EINVAL;
>>>>>>>>     }
>>>>>>>> 
>>>>>>>> -    __copy_to_guest(runstate_guest(v), &runstate, 1);
>>>>>>>> +    v->arch.runstate_guest.page = page;
>>>>>>>> +    v->arch.runstate_guest.offset = offset;
>>>>>>>> +
>>>>>>>> +    spin_unlock(&v->arch.runstate_guest.lock);
>>>>>>>> +
>>>>>>>> +    return 0;
>>>>>>>> +}
>>>>>>>> +
>>>>>>>> +
>>>>>>>> +/* Update per-VCPU guest runstate shared memory area (if registered).
>>>>>>>> */
>>>>>>>> +static void update_runstate_area(struct vcpu *v)
>>>>>>>> +{
>>>>>>>> +    struct vcpu_runstate_info *guest_runstate;
>>>>>>>> +    void *p;
>>>>>>>> +
>>>>>>>> +    spin_lock(&v->arch.runstate_guest.lock);
>>>>>>>> 
>>>>>>>> -    if ( guest_handle )
>>>>>>>> +    if ( v->arch.runstate_guest.page )
>>>>>>>>     {
>>>>>>>> -        runstate.state_entry_time &= ~XEN_RUNSTATE_UPDATE;
>>>>>>>> +        p = __map_domain_page(v->arch.runstate_guest.page);
>>>>>>>> +        guest_runstate = p + v->arch.runstate_guest.offset;
>>>>>>>> +
>>>>>>>> +        if ( VM_ASSIST(v->domain, runstate_update_flag) )
>>>>>>>> +        {
>>>>>>>> +            v->runstate.state_entry_time |= XEN_RUNSTATE_UPDATE;
>>>>>>>> +            guest_runstate->state_entry_time |= XEN_RUNSTATE_UPDATE;
>>>>>>> 
>>>>>>> I think that this write to guest_runstate should use write_atomic or
>>>>>>> another atomic write operation.
>>>>>> 
>>>>>> I thought about suggesting the same, but  guest_copy_* helpers may not
>>>>>> do a single memory write to state_entry_time.
>>>>>> What are you trying to prevent with the write_atomic()?
>>>>> 
>>>>> I am thinking that without using an atomic write, it would be (at least
>>>>> theoretically) possible for a guest to see a partial write to
>>>>> state_entry_time, which is not good. 
>>>> 
>>>> It is already the case with existing implementation as Xen may write byte 
>>>> by
>>>> byte. So are you suggesting the existing code is also buggy?
>>> 
>>> Writing byte by byte is a different case. That is OK. In that case, the
>>> guest could see the state after 3 bytes written and it would be fine and
>>> consistent. If this hadn't been the case, then yes, the existing code
>>> would also be buggy.
>>> 
>>> So if we did the write with a memcpy, it would be fine, no need for
>>> atomics:
>>> 
>>> memcpy(&guest_runstate->state_entry_time,
>>>        &v->runstate.state_entry_time,
>>>        XXX);
>>> 
>>> 
>>> The |= case is different: GCC could implement it in any way it likes,
>>> including going through a zero-write to any of the bytes in the word, or
>>> doing an addition then a subtraction. GCC doesn't make any guarantees.
>>> If we want guarantees we need to use atomics.
>> 
>> Wouldn’t that require all accesses to state_entry_time to use also atomic 
>> operations ?
>> In this case we could not propagate the changes to a guest without changing 
>> the interface itself.
>> 
>> As the copy time needs to be protected, the write barriers are there to make 
>> sure that during the copy the bit is set and that when we unset it, the copy 
>> is done.
>> I added for this purpose a barrier after the memcpy to make sure that 
>> when/if we unset the bit the copy has already been done.
> 
> As you say, we have a flag to mark a transitiong period, the flag is
> XEN_RUNSTATE_UPDATE. So, I think it is OK if we don't use atomics during
> the transitioning period. But we need to make sure to use atomics for the
> update of the XEN_RUNSTATE_UPDATE flag itself.
> 
> Does it make sense? Or maybe I misunderstood some of the things you
> wrote?

To achieve this you would do an atomic operation on state_entry_time to 
set/unset the XEN_RUNSTATE_UPDATE bit.
This field is holding a flag in the upper bit but also a value, so all 
operations on state_entry_time would need to be changed to use atomic 
operations.

Also this state_entry_time might also be accessed by the guest on other cores 
at the same time (to retrieve the time part).

To prevent something being used as atomic and non atomic, specific types are 
usually used (atomic_t) and this structure is also used by guests so modifying 
it will not be easy.

Or did I missunderstood something here ?

Regards
Bertrand