[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH v6 05/11] x86/hyperv: setup hypercall page



On Mon, Feb 03, 2020 at 04:32:52PM +0100, Jan Beulich wrote:
> On 03.02.2020 16:21, Roger Pau Monné wrote:
> > On Mon, Feb 03, 2020 at 03:07:24PM +0000, Wei Liu wrote:
> >> On Mon, Feb 03, 2020 at 04:01:54PM +0100, Roger Pau Monné wrote:
> >>> On Fri, Jan 31, 2020 at 05:49:24PM +0000, Wei Liu wrote:
> >>>> Hyper-V uses a technique called overlay page for its hypercall page. It
> >>>> will insert a backing page to the guest when the hypercall functionality
> >>>> is enabled. That means we can use a page that is not backed by real
> >>>> memory for hypercall page.
> >>>>
> >>>> Use the top-most addressable page for that purpose. Adjust e820 map
> >>>> accordingly.
> >>>
> >>> Can you add this is done to avoid page shattering and to make sure
> >>> Xen isn't overwriting any MMIO area which might be present at lower
> >>> addresses?
> >>
> >> NP.
> >>
> >>>
> >>>> +
> >>>> +static void __init e820_fixup(struct e820map *e820)
> >>>> +{
> >>>> +    uint64_t s = HV_HCALL_MFN << PAGE_SHIFT;
> >>>> +
> >>>> +    if ( !e820_add_range(e820, s, s + PAGE_SIZE, E820_RESERVED) )
> >>>
> >>> I think end should be s + PAGE_SIZE - 1, or else it expands across two
> >>> pages?
> >>
> >> No, it shouldn't.
> >>
> >> E820 entry records the size of the region, which is calculated as
> >> end-start. The one usage in pv/shim.c follows the same pattern here.
> > 
> > Hm, I see. I'm not sure this is correct, I think the e820 entry
> > should look like:
> > 
> > addr = s;
> > size = PAGE_SIZE - 1;
> > 
> > As ranges on the e820 are inclusive, so if size ends up being
> > PAGE_SIZE then the entry would expand across two pages.
> 
> Ranges can sensibly be inclusive only when specified as [start,end]
> tuples. (start,size) pairs make no sense for representing
> [start,start+size], they only make sense for [start,start+size).
> Otherwise, as in your example above, size taken on its own is off
> by one (i.e. is rather "last byte" than "size").
> 
> Modern Linux, when logging the memory map, indeed subtracts 1 from
> the sum of addr and size, to show an inclusive range.

We should perhaps do the same then.

If people agree this is the way to go, I can write a patch.

Wei.

> 
> Jan

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.