Re: [Xen-devel] Errors with Loading Xen at a Certain Address

[Julien Grall <julien.grall@xxxxxxx>]

Hi,

On 03/10/2019 00:20, Brian Woods wrote:
> On Wed, Oct 02, 2019 at 02:22:49PM -0700, Brian Woods wrote:
> > On Wed, Oct 02, 2019 at 08:59:28PM +0100, Julien Grall wrote:
> > > Hi,
> > >
> > > On 10/2/19 7:56 PM, Brian Woods wrote:
> > >
> > > Hmmm, the first e-mail didn't land in my inbox directly (I have a filter
> > > send to a separate directory any e-mail I not CCed on). Did you BCC me by
> > > any change?
> > That's odd.  I know I copied your and Stefano's email addresses from the
> > MAINTAINERS file but under my sent emails it shows it has having no
> > CCs...  PEBCAK I guess.  My apologies.
> > > Let see try to troubleshoot it first :).
> > >
> > > Well, any attachment you send on the ML will store to each subscribers
> > > mailbox. I let you do the math here ;)
> > >
> > > So yeah, pastebin is always the preferred way when you have to send the full
> > > log.
> > >
> > > Thank you for the log. So that's probably not a double-init then.
> > >
> > > Looking back at the log, the values look quite sane. So I am not entirely
> > > sure what is happening.
> > >
> > > I would check that the frametable is correctly zeroed. You could add a print
> > > at the end of setup_frametable_mappings(...) to dump the count_info for the
> > > page. Something like:
> > >       mfn_to_page(_mfn(0x01533))->count_info;
> > >
> > > If it is correctly initialized, it should be zero.
> > >
> > > The next step would be to add a similar print in start_xen()
> > > (xen/arch/arm/setup.c) and see where the value is not 0 anymore.
> > >
> > > Cheers,
> > >
> > > --
> > > Julien Grall
> > I'll go ahead add those and see if that leads to anything.
> >
> > --
> > Brian Woods
> Ok, I added:
>         printk("BW_DEBUG: 01 count_info=0x%016lx\n",
>             mfn_to_page(_mfn(0x01533))->count_info);
> In some places.  I'm not sure about some of the earlier ones (the ones
> before the UART is set up),  but all of the ones afterwards that
> actually get output are:
>         BW_DEBUG: 11 count_info=0x0180000000000000
>
> Is it worth trying to figure out where the printk buffer is and reading
> it really early on?
If you haven't enable EARLY_PRINTK in Xen, then you may want to do it. This 
would help you to understand where the page->count_info is not zeroed.

Cheers,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel