Re: [Xen-devel] [PATCH v4 18/27] xen: Adapt assembly for PIE support

[Thomas Garnier <thgarnie@xxxxxxxxxx>]

On Fri, Jun 1, 2018 at 8:40 AM Boris Ostrovsky
<boris.ostrovsky@xxxxxxxxxx> wrote:
>
> On 05/29/2018 06:15 PM, Thomas Garnier wrote:
> > diff --git a/arch/x86/xen/xen-pvh.S b/arch/x86/xen/xen-pvh.S
> > index ca2d3b2bf2af..82ba89ba8bb3 100644
> > --- a/arch/x86/xen/xen-pvh.S
> > +++ b/arch/x86/xen/xen-pvh.S
> > @@ -114,8 +114,8 @@ ENTRY(pvh_start_xen)
> >       call xen_prepare_pvh
> >
> >       /* startup_64 expects boot_params in %rsi. */
> > -     mov $_pa(pvh_bootparams), %rsi
> > -     mov $_pa(startup_64), %rax
> > +     movabs $_pa(pvh_bootparams), %rsi
> > +     movabs $_pa(startup_64), %rax
> >       jmp *%rax
> >
> >  #else /* CONFIG_X86_64 */
> > @@ -161,10 +161,15 @@ END(pvh_start_xen)
> >
> >       .section ".init.data","aw"
> >       .balign 8
> > +     /*
> > +      * Use a quad for _pa(gdt_start) because PIE does not understand a
> > +      * long is enough. The resulting value will still be in the lower long
> > +      * part.
> > +      */
> >  gdt:
> >       .word gdt_end - gdt_start
> > -     .long _pa(gdt_start)
> > -     .word 0
> > +     .quad _pa(gdt_start)
>
>
> With this becoming .quad 32-bit compilation fails:
>
> /data/root/linux/arch/x86/xen/xen-pvh.S: Assembler messages:
> /data/root/linux/arch/x86/xen/xen-pvh.S:147: Error: cannot represent
> relocation type BFD_RELOC_64

Thanks, I will look to fix this in the next patch set and run a full
32-bit build.

>
>
> -boris
>
>
> > +     .balign 8
> >  gdt_start:
> >       .quad 0x0000000000000000            /* NULL descriptor */
> >  #ifdef CONFIG_X86_64
>


-- 
Thomas

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel