Re: [Xen-devel] Unable to boot Xen 4.7-rc4 on HiKey

[Tamas K Lengyel <tamas.k.lengyel@xxxxxxxxx>]

On Wed, Jun 1, 2016 at 3:49 PM, Julien Grall <julien.grall@xxxxxxx> wrote:
> On 01/06/2016 18:10, Tamas K Lengyel wrote:
>>
>> Hi all,
>
>
> Hi Tamas,
>
>> following the steps from http://wiki.xen.org/wiki/HiKey I'm unable to
>> get the board to boot Xen. I'm using the Debian reference image from
>> linaro as base
>> (https://builds.96boards.org/releases/hikey/linaro/debian/latest/)
>> and that boots fine both from the SD card directly and through
>> startup.nsh. However, when I try to boot Xen I see only the following:
>>
>> Xen 4.7.0-rc (c/s Mon May 23 12:07:20 2016 +0100 git:8478c94-dirty) EFI
>> loader
>> Using configuration file 'xen.cfg'
>> Image: 0x000000007a121000-0x000000007acb8a70
>>
>> After that no output and dom0 never comes online on the network
>> either. I tried compiling Xen on the device itself in case it was a
>> problem with my cross-compile setup but no difference. Also with and
>> without debug=y. Any tips on what might be going wrong here?
>
>
> I gave a quick look at the upstream device-tree of the hikey, the path
> /smb/uart@f7113000.
>
> If you use the upstream device-tree, it should be able to find the correct
> UART via "stdout-path" and therefore dtuart=... should not be necessary.
>
> Let me know if it works for you, and I will update the wiki page.

It doesn't unfortunately, without specifying dtuart=... I still see no
Xen output.

Tamas

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel