Re: [Xen-devel] [RFC 00/29] Incomplete Kconfig conversion

[Andrew Cooper <andrew.cooper3@xxxxxxxxxx>]

On 06/10/15 10:39, Andrew Cooper wrote:
> On 05/10/15 23:03, Doug Goldstein wrote:
>> This is very incomplete and is only posted in hopes of getting some feedback
>> if this conversion is welcome by the community. There are a few different
>> ways I can go from here.
>>
>> * convert all of include/$(ARCH)/config.h
>> * move this to the top level and convert all of configs/
>> * due both of the above
>>
>> I'd like to break this series up as small as possible and land parts in the
>> tree that I can land. At this point the first 4 patches are too large and
>> need culling down to only what's necessary. But my goal was to make it as
>> obvious as possible where the original code came from and how it was
>> transformed over time.
>>
>> Ultimately my goal is to allow for more parts of the hypervisor to be turned
>> off at compile time and potentially make it easier to include more
>> experimental features by others which can be turned off by default. Also to
>> provide the one true location for all possible knobs in the source code.
> Thankyou for looking into this.  Do you by any chance have a git tree
> with this in?

Sorry for the noise - I should have read the thread a little more before
asking.

~Andrew

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel