[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [Xen-users] ARM: Xen on Vexpress



On Wed, 2014-06-18 at 09:40 +0100, Julien Grall wrote:
> 
> On 18/06/14 09:29, Ian Campbell wrote:
> > On Tue, 2014-06-17 at 18:50 +0100, Julien Grall wrote:
> >> (CCing Xen-devel)
> >>
> >> On 06/16/2014 05:32 PM, Jeenu Viswambharan wrote:
> >>> On Thu, Jun 12, 2014 at 15:50:02, Jeenu Viswambharan wrote:
> >>>>>>    - What does DOM0 see as its PC at entry?
> >>>>>
> >>>>> The load address of the kernel image, since the zImage protocol
> >>>>> requires us to enter the kernel at that offset.
> >>>>
> >>>> I managed to break at eret before guest entry, and the PC is
> >>>> 0xafc00000 itself. It does fail to boot bare metal too from that
> >>>> address. I'll see if I can find what's going wrong.
> >>>
> >>> I've been told that loading Linux at that high an offset from the memory
> >>> base wouldn't work after all, even on bare metal. I therefore set
> >>> kernel_addr_r to 0x80008000, which makes Xen load DOM0 at 0x8fc00000. I
> >>> can see Linux starting to boot from this address on bare metal, but With
> >>> Xen I'm seeing "uncompression error" (not printed on to the console, but
> >>> through debugger inspection).
> >>>
> >>> I haven't pinned down why exactly it's throwing this. While I'm at it,
> >>> I'd appreciate any helpful pointers.
> >>
> >> Did you try to use CONFIG_VMSPLIT_3G rather than CONFIG_VMSPLIT_2G as I
> >> suggested last week?
> >>
> >> Using CONFIG_VMSPLIT_3G works correctly with 3.15. It looks like another
> >> issue in the pa - virt delta when it's positive.
> >>
> >> IIRC, it's because linux is assuming that delta is always negative (see
> >> comment on __PV_BITS_31_24 in arch/arm/include/asm/memory.h).
> >>
> >> At first glance, handling positive offset will be hard because, their
> >> are rely on the compiler to provide the right layout for the
> >> instruction. Positive number is not encoded the same way. I will have to
> >> spend a bit more time to fully understand this code.
> >>
> >> With Ian multiple bank support patch for DOM0, I think we can safely
> >> assume that the delta will (nearly?) always be the same.
> >
> > That would be a coincidence of the implementation, not a guarantee which
> > we would make.
> >
> > If there is an issue with the pa - virt delta handling then we should
> > raise it with Linux upstream.
> 
> I will raise again the issue to Linux.

Thank you.

>  But I start to think this is a 
> restriction by Linux but I can't find a clear comment about it. Not much 
> (maybe none of) ARM platform has the start physical address very high.

I wouldn't be terribly surprised if there were platforms with RAM
starting at 3GB, which would break with VMSPLIT_2G and VMSPLIT_1G and
I'm sure there are platforms with ram at 2GB which would fail with
VMSPLIT_1G (vexpress falls into this category, I think).

In the days before multiplatform this was fine -- the restriction could
be expressed in Kconfig, but these days I don't think that flies...

Ian.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.