[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] which branch should be used as dom0 on arndale

On 10/30/2013 02:57 PM, mail fetch wrote:
2013/10/30 mail fetch <fetchmail.0104@xxxxxxxxx

    Hi Julien,


    I found there are lots of branches under linux-arm.git. Xen wiki
    recommends to use branch arndale. But i found it lacks of the
    following configuration in dts file which is exist in branch
    arndale-dom0-3.10. Should i use arndale or arndale-dom0-3.10 as dom0?
    Can Xen boot up without those configuration?

U-boot will automatically create the nodes in the device tree with the following script:
All details are given by the wiki page.

    chosen {
                    bootargs = "dom0_mem=256M sync_console console=dtuart
    dtuart=serial2 earlyprintk=xen";
                    xen,dom0-bootargs = "console=hvc0,115200n8
    earlyprintk=xen debug ignore_loglevel psci=enable clk_ignore_unused
                    modules {
                            module@0 {
                                    compatible = "xen,linux-zimage",
                                    reg = <0x60000000 0x500000>;

    best regards

Any ideas?

You should avoid to ping after only a couple of hours... we can work in a different timezone or be away for conferences/holidays.
I think 1 week is the minimum delay between 2 pings.


Julien Grall

Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.