[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Bug: Windows 2003 fails to install on xen-unstable tip

On 23/04/13 15:55, Jan Beulich wrote:
On 23.04.13 at 16:21, George Dunlap <george.dunlap@xxxxxxxxxxxxx> wrote:
On 23/04/13 14:00, Jan Beulich wrote:
On 23.04.13 at 13:52, George Dunlap <george.dunlap@xxxxxxxxxxxxx> wrote:
On 23/04/13 12:33, Jan Beulich wrote:
Just went through that change again: The only thing that changes
is that while rtc_periodic_cb() (simply setting REG_C flags) got
called at the end of pt_intr_post(), rtc_periodic_interrupt() now
gets called from pt_update_irq(), and therefore takes care of
asserting the IRQ itself (which originally happened inside
pt_update_irq()) along with setting REG_C flags. Bottom line -
all the patch changes is when exactly REG_PF (and possibly
REG_IRQF) get set, and whether the IRQ actually gets asserted.
So that last bit seems to do these things:
a. Changes when the handling happens in the Xen interrupt handler
b. Causes assert/deassert to only happen if !(C.PF) && (B.PIE)
    (Before it happened unconditionally)
c. Causes C.IRQF=1 only if (same condition above)
   (Before it happened unconditionally)
d. Runs destroy_periodic_timer() if C.PF already

So just to figure out what it was that w2k3 wanted, I tried a bunch of

* All of above
* a only; always assert/deassert + set C.IRQF
* always assert/deassert, but leave destroy_periodic_timer and IRQF
setting alone
* destroy if C.PF, assert/deassert, set IRQF if setting C.PF (don't
check B.PIE)
* destroy if C.PF, always assert/deassert + set C.IRQF
* never destroy, assert/deassert + set C.IRQF if setting C.PF
* never destroy, assert/deassert + set C.IRQF if !C.IRQF

In short, it seems that w2k3 basically expects an unlimited number of
attempts to actually deliver the interrupt.
Not always doing the deassert/assert pair was actually part of Tim's
subsequent changes - before that it got called conditionally upon
B.PIE, but always set C.IRQF and always deasserted and asserted.
Since we know from the debug log that B.PIE is set, I fail to see how
the code prior to "x86/hvm: Centralize and simplify the RTC IRQ logic"
would have not worked, but the above case turned out GOOD.

So did his earlier 3 changes perhaps fix the issue, and the fourth re-
introduced it?

If you've got a git hash I can try to revert it.


Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.