[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] EHCI/Xen: propagate controller reset information to hypervisor



On Tue, Sep 18, 2012 at 10:42:30AM -0400, Konrad Rzeszutek Wilk wrote:
> On Tue, Sep 18, 2012 at 12:23:02PM +0100, Jan Beulich wrote:
> > Just like for the in-tree early console debug port driver, the
> > hypervisor - when using a debug port based console - also needs to be
> > told about controller resets, so it can suppress using and then
> > re-initialize the debug port accordingly.
> > 
> > Other than the in-tree driver, the hypervisor driver actually cares
> > about doing this only for the device where the debug is port actually
> > in use, i.e. it needs to be told the coordinates of the device being
> > reset (quite obviously, leveraging the addition done for that would
> > likely benefit the in-tree driver too).
> > 
> > Signed-off-by: Jan Beulich <jbeulich@xxxxxxxx>
> 
> Acked-by: Konrad Rzeszutek Wilk <konrad.wilk@xxxxxxxxxx>
> 
> on the *xen* parts.

So, I'm guessing this should go in through the USB tree?  If there are
no objections, I'll do that.

greg k-h

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.