[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-devel] [PATCH] docs: clarify documentation for the the dom0_mem command line option



From: David Vrabel <david.vrabel@xxxxxxxxxx>

Signed-off-by: David Vrabel <david.vrabel@xxxxxxxxxx>
---
This addresses Ian C's comments on v1 of a previous patch (which
was applied instead of v2).
---
 docs/misc/xen-command-line.markdown |   22 +++++++++++++++-------
 1 files changed, 15 insertions(+), 7 deletions(-)

diff --git a/docs/misc/xen-command-line.markdown 
b/docs/misc/xen-command-line.markdown
index c697d68..fb78afe 100644
--- a/docs/misc/xen-command-line.markdown
+++ b/docs/misc/xen-command-line.markdown
@@ -222,19 +222,27 @@ Specify the total size for dom0.
 > `= List of ( min:<size> | max:<size> | <size> )`
 
 Set the amount of memory for the initial domain (dom0). If a size is
-positive, it represents an absolute value.  If a size is negative, the
-size specified is subtracted from the total available memory.
+positive, it represents an absolute value.  If a size is negative, it
+is subtracted from the total available memory.
 
-* `min:<size>` specifies the minimum amount of memory allocated to dom0.
-* `max:<size>` specifies the maximum amount of memory allocated to dom0.
-* `<size>` specified the exact amount of memory allocated to dom0.
+* `<size>` specifies the exact amount of memory.
+* `min:<size>` specifies the minimum amount of memory.
+* `max:<size>` specifies the maximum amount of memory.
+
+If `<size>` is not specified, the default is all the available memory
+minus some reserve.  The reserve is 1/16 of the available memory or
+128 MB (whichever is smaller).
+
+The amount of memory will be at least the minimum but never more than
+the maximum (i.e., `max` overrides the `min` option).  If there isn't
+enough memory then as much as possible is allocated.
 
 `max:<size>` also sets the maximum reservation (the maximum amount of
 memory dom0 can balloon up to).  If this is omitted then the maximum
 reservation is unlimited.
 
-For example, to set dom0's memory to 512 MB but no more than 1 GB use
-`dom0_mem=512M,max:1G`.
+For example, to set dom0's initial memory allocation to 512MB but
+allow it to balloon up as far as 1GB use `dom0_mem=512M,max:1G`
 
 ### dom0\_shadow
 ### dom0\_vcpus\_pin
-- 
1.7.2.5


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.