Re: [Xen-devel] Xen 4.0 with Remus on Suse 10.1??

[Sander Eikelenboom <linux@xxxxxxxxxxxxxx>]

Hello Kenneth,

Would perhaps be handy if you could post your grub config, and the steps you 
took to build and install Xen 4.

A pointer when using grub2  could be 
http://wiki.xensource.com/xenwiki/XenCommonProblems

--

Sander

Wednesday, May 12, 2010, 5:49:34 PM, you wrote:

> Hello,

> I am trying to set up a Xen/Remus test configuration on AMD64 hardware
> (HP DL380 G6) under SuSE 10.1 and am having trouble.

> I was able to run and configure the Xen 3 that came with SuSE fine, but
> as far as I can see, I have to use Xen 4 to get Remus.

> I managed to build Xen 4  from source and it seemed to install, but I am
> not sure how to get the proper kernel and/or initrd files in place in
> GRUB to get it to work.

> Alternatively, is there a way to install Remus into my older Xen 3 which
> was working?  I have not been able to find a Remus source anywhere.

> Thank you for any  help or pointers to the right places to look.   

> Regards,
> -k


> Kenn Lippert
> Computation & Simulation Modeling, 
> Product Manufacturing Division
> Alcoa Technical Center.
> Tel: 724-337-2691
> Email: kenneth.lippert@xxxxxxxxx









-- 
Best regards,
 Sander                            mailto:linux@xxxxxxxxxxxxxx


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel