[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Using xen-unstable, dom0 hangs during boot



On 02/25/2010 02:18 PM, Nadolski, Ed wrote:
I'm running Fedora 12 (kernel 2.6.31.5-127.fc12.x86_64) on a Dell T7500 Xeon 
with VT-x and VT-d. After building xen-unstable and rebooting, the dom0 Linux 
hangs a few seconds after it gets control from Xen, and I have to power-cycle 
to recover.   Here are the last messages before it hangs:

[    2.766882] loop: module loaded
[    2.767736] input: Macintosh mouse button emulation as 
/devices/virtual/input/input2
[    2.769396] xen_set_ioapic_routing: irq 20 gsi 20 vector 20 ioapic 0 pin 20 
triggering 1 polarity 1
[    2.770342] achi 0000:00:1f.2: PCI INT C ->  GSI 20 (level, low) ->  IRQ 20
[    2.771158] ahci 0000:00:1f.2: AHCI 0001.0200 32 slots 6 ports 3 Gbps 0x27 
impl SATA mode
[    2.772078] ahci 0000:00:1f.2: flags: 64bit ncq sntf led clo pio ems
<<hangs at this point>>

Thoughts?  Any grub parameters I should try for Linux and/or Xen?  Any further 
info I can provide?

What kernel is this?  What's the boot command line?

    J

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.