[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] Disable Xen PowerNow! support on Opteron 2nd gen and earlier processors



Are we in fact talking about the new Barcelona chips? If so, their frequency settings are independent per core. Unless I have misunderstood the question.

Shingoshi



Keir Fraser wrote:
On 25/1/08 22:58, "Mark Langsdorf" <mark.langsdorf@xxxxxxx> wrote:

  
I tried this suggestion and also implemented the trace function in
cpu_frequency_change() and local_time_calibration() you suggested in
a previous message.

It made no discernable difference in my tests.  I did high to low
and low to high changes roughly every five minutes, and always got
an excessive difference inside of Xen and usually got error messages
in Linux.
    

It's a bit confusing as to what is going on since there are 4 CPUs in the
system. Are arbitrary or all CPUs changing frequency, or just one of them?
Is the single-step PSTATE_CTRL MSR being used, or the multi-step FID_VID
method where voltage adjustments are under software control? What is the
system's CPU topology, and do any of the cores have their frequency controls
tied together?

It'd be useful to have each tracing line stamped with the CPU that it comes
from. As it is the tracing looks very suspect because the systimes on
adjacent lines are much less than one second, and calibration is supposed to
happen no more than once per second.

 -- Keir



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel

  
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.