Re: [Xen-devel] No console with xen-3.2

[Keir Fraser <Keir.Fraser@xxxxxxxxxxxx>]

Did the system actually boot, just with no console output, or might the
system simply have been toast?

Also, from where did you get Xen 3.2? Since it doesn't exist yet, did you
pull and build the xen-unstable repo?

 -- Keir

On 13/11/07 15:18, "Chuck Short" <zulcss@xxxxxxxxx> wrote:

> No output at all.
> 
> On Nov 13, 2007 10:10 AM, Keir Fraser <Keir.Fraser@xxxxxxxxxxxx> wrote:
>> Do you mean you cannot type input at the vga console, or do you mean there
>> is no output at all? Does output from Xen appear, but not from dom0?
>> 
>>  -- Keir
>> 
>> 
>> On 13/11/07 13:40, "Chuck Short" <zulcss@xxxxxxxxx> wrote:
>> 
>>> Hi,
>>> 
>>> I installed Xen-3.2 last night and setup the grub.conf and kernel as
>>> usual. However, when I rebooted I did not get an console input when
>>> booting the dom0. I tried adding the console=vga to my grub.conf as
>>> shown below:
>>> 
>>> title xen-3.2
>>> root (hd0,0)
>>> kernel /boot/xen-3.2.gz console=vga
>>> module  /boot/vmlinuz-2.6.18.8
>>> root=UUID=7373696f-c367-4a6a-b198-17e593508cc8 ro console=tty0
>>> module /boot/xen-2.6.18
>>> quiet
>>> 
>>> I am not sure where to go from here.
>>> 
>>> Thanks
>>> chuck
>>> 
>>> _______________________________________________
>>> Xen-devel mailing list
>>> Xen-devel@xxxxxxxxxxxxxxxxxxx
>>> http://lists.xensource.com/xen-devel
>> 
>> 
>> 
> 
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel