[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Data broken during FTP test

Hi All,

I'm sorry the mistake was found in mail.
It is a mistake of not DomVTi but DomVTx.

Best Regards,

Takanori Kasai

----- Original Message ----- From: "Kasai Takanori" <kasai.takanori@xxxxxxxxxxxxxx> To: "Ian Pratt" <Ian.Pratt@xxxxxxxxxxxx>; "Keir Fraser" <Keir.Fraser@xxxxxxxxxxxx>
Cc: "xen-devel" <xen-devel@xxxxxxxxxxxxxxxxxxx>
Sent: Thursday, May 24, 2007 6:33 PM
Subject: Re: [Xen-devel] Data broken during FTP test

Hi Ian and Keir,

I'm sorry for delaying response.

Can you reproduce if you uninstall the RHEL5 xen/kernel and xen tools
and libs RPMs and then install binaries built from xen-unstable?

We will reproduce it with xen-unstable.hg.

We tested it with the same machine.
The environment is as follows.

Xen :
- xen-unstable.hg: cs15072
NICs :
- Broadcom Corporation NetXtreme BCM5715 Gigabit Ethernet (rev a3)
- Intel Corporation 82545GM Gigabit Ethenet Controller (rev 04)
Guests :
- DomU
- SG and TSO flag: ENABLE
- Memory
   ・Domain0       : 1GByte
   ・Guest Domains : 2GByte

The test result was not reproduced as follows.

                           |    Broadcom   |    Intel
 DomU                      |   Not broken  |   Not broken
 DomVTi(RHEL5GA)           |   Not broken  |   Not broken
 DomVTi(RHEL5GA)+VNIF      |   Not broken  |   Not broken

Next, the tg3 driver and the e1000 driver were replaced with RHEL5GA.
However, the result was not reproduced similarly.

Is there a correction related to this problem since xen3.0.3?

Best Regards,

Takanori Kasai

Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.