[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [RFC] keymap support for PVFB



Hi Markus,

I checked that the result of conversion had passed PVFB and gone out of
fbflont.
I think that the conversion by the OS side will go wrong.

If you know how it will pass from guest OS to guest OS's X,
please give me some comments.

When I input "\",  following message a display each modules

PVFB:
keycode 92(0x5C) -> scancode 115

xev:
keycode 176   keysym 0x0, NoSymbol


Thanks,
-
Junko Ichino


----- Original Message ----- From: "Markus Armbruster" <armbru@xxxxxxxxxx>
To: "Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx>
Cc: <Xen-devel@xxxxxxxxxxxxxxxxxxx>
Sent: Friday, January 12, 2007 2:54 AM
Subject: Re: [Xen-devel] [RFC] keymap support for PVFB


"Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx> writes:

Hi Markus,

Thank you for your reply.

The key that doesn't work is \, | , _ , arrow (UP, DOWN, LEFT, and RIGHT),
Hankaku/Zenkaku , Muhenkan , Katakana/Hiragana and so on.
(When you do not know about Hankaku/Zenkaku etc., please question the
Japanese
who is in near.)

When I looked at atkbd.c, it seemed to change scancode again.
I put in the same conversion immediately after changing into scancode
from keysym by PVFB.
However, it failed.

I investigate this problem continuously.

How can we help?

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.