Re: [Xen-devel] dom0 won't boot

[Barry Rountree <rountree@xxxxxxxxxx>]

On Thursday 29 July 2004 08:29 pm, Ian Pratt wrote:

> All of that output is from grub, you're not seeing anything from
> Xen.
>
> Try "com1=115200,8n1" and make sure that you've got the baudrate
> at the other end set correctly (I thought grub defaulted to 9600?)

It's set correctly -- I had never done this before, so there was a bit of a 
learning curve.  I practiced on the smp kernel that I usually boot into and 
when I was able to capture everything in minicom there I switched over to 
xen.  If I had gotten no output at all, it would have been suspicious.  
However, I did get output, no characters were garbled, no sentences cut in 
half, etc.

For whatever it's worth, here's the entry in grub:

title Xen-Serial
serial --unit=0 --speed=9600 --word=8 --parity=no --stop=1
terminal serial
kernel (hd0,4)/boot/xen.gz dom0_mem=131072 com1=115200 noht noreboot
module (hd0,4)/boot/vmlinuz-2.4.26-xen0 root=/dev/sda5 ro console=ttyS0

But still, a good point.

Barry
>
> Ian


-------------------------------------------------------
This SF.Net email is sponsored by OSTG. Have you noticed the changes on
Linux.com, ITManagersJournal and NewsForge in the past few weeks? Now,
one more big change to announce. We are now OSTG- Open Source Technology
Group. Come see the changes on the new OSTG site. www.ostg.com
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel