Re: [Wg-test-framework] Baroque 0/1 Status

[Ian Jackson <Ian.Jackson@xxxxxxxxxxxxx>]

Paul L. George writes ("Baroque 0/1 Status"):
> We setup the BIOS and reloaded the OS as a test on both baroque 0/1.  We
> reinstalled them both back at the COLO.

Thanks.

Are you sure that everything was done as intended ?  My understanding
is that you intended to replace the motherboard on baroque1.

However, the onboard NIC MAC addresses aren't what I expect:

                                 baroque0           baroque1

 NIC1 MAC recorded in ansible,   00:1e:67:99:42:9d  00:1e:67:99:46:e4
 from before hardware work (also
 visible in old serial logs)

 NIC1 MAC reported by BIOS,      00:1e:67:af:e4:34  00:1e:67:99:46:e4
 now, after hardware work

Also the disk wiring is unexpected:

 WDC hard disk connection        SATA 1             SATA 0
 now, as reported by BIOS

 WDC hard disk connection        ata1.00            ata1.00
 before, as reported by Linux

For reference:

 Motherboard serial number       BQRP41602880       BQRP33601232
 now (as reported by BIOS)


Are you sure you replaced the motherboard in the correct machine ?

It seems likely that (a) the motherboard in baroque0 has been replaced
and (b) the hard disk SATA cable was plugged into a different
connector when the machine was reassembled.

Thanks,
Ian.

_______________________________________________
Wg-test-framework mailing list
Wg-test-framework@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/wg-test-framework