Re: [Wg-test-framework] COLO Cabinet Layout-12.xlsx

[Don Slutz <dslutz@xxxxxxxxxxx>]

On 04/14/15 13:35, Ian Jackson wrote:
> Paul L. George writes ("COLO Cabinet Layout-12.xlsx"):
>> New Layout attached, we are going to put the rimava 0/1 systems above the ARM
>> crate when we get the new power supplies.  There is a grounding bolt at the
>> bottom of the rack that makes getting the server to slide into the rack very
>> hard.  It is also very hard to work on the server at floor level.
> 
> Thanks.  I see Don Slutz copied that into git.  I have renamed the
> file to `COLO Cabinet Layout.xlsx'.  We don't need version numbers in
> filenames when the file is in a revision control system ...
> 

Opps, forgot to fix.  Thanks for the adjustment.
   -Don Slutz

> 
>> Oscelata 0/1 were tested and the BIOS for each system was updated to 2.3.0.
>>
>> Oscelata 1 & 0 are back in the rack. Dell replaced the mother board in 
>> Oscelata
>> 1 due to a failure discovered while testing the BIOS update.
>>
>> New MAC for Eh0 ? 08:9e:01:62:dd:89
>>
>> New MAC for Eth1 -  08:9e:01:62:dd:8A   
>>  
>>
>> Both systems were BOOT tested for hours without any failures..
> 
> Thanks.
> 
> Does that mean you are handing these machines back to me ?  If so I
> will run another set of commissioning tests.
> 
> Thanks,
> Ian.
> 
> _______________________________________________
> Wg-test-framework mailing list
> Wg-test-framework@xxxxxxxxxxxxxxxxxxxx
> http://lists.xenproject.org/cgi-bin/mailman/listinfo/wg-test-framework
> 

_______________________________________________
Wg-test-framework mailing list
Wg-test-framework@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/wg-test-framework