Re: [Xen-users] vlan id configuration on domU on Xen

["Fajar A. Nugraha" <fajar@xxxxxxxxx>]

On Mon, Jan 11, 2010 at 2:21 PM, Bhargava Ramu Kavati
<ramu.kavati@xxxxxxxxx> wrote:
> Hi,
> I am using the below procedure for vlan configuration with ethernet
> interface sharing on Xen.
> i) configure vlan on interface that is to be shared.
>    vconfig add ethx 5
> ii) Call the below script from xend-config file.
>     dir=$(dirname "$0")
>     "$dir/network-bridge" "$@" netdev=ethx.5 vifnum=0 bridge=xenbr0V5
> iii) Use the bridge created above in VM's config file.
> iv) Ping from all the VMs (to which ethx.5 is shared) to external host
> (which is already in vlan id 5) succeeds.
> If we want to verify the same scenario on ESXi, first vswitch needs to be
> configured with vlan id 4095 and the VM need to be configured with vlan id 5
> ("vconfig add ethx 5" on VM).  Then ping from VM to external host (already
> in vlan id 5) succeeds.
> Whereas in case of Xen, we did not configure the VM's interface using
> "vconfig add".  We just attached VM's interface to xenbr created.
>
> Can you please clarify why the approach is different on Xen when compared to
> ESXi.

Depends on your design and what you need. The ESXi approach that you
mention basically assigns the whole trunk to VMs. You can do the same
thing with Xen if you want, bridging ethx instead of ethx.5.

The main question is, do you trust your VM users enough to give them
trunk access?

-- 
Fajar

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users