This is great info - thanks! :)
Nathan
-----Original Message-----
From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Angel L. Mateo
Sent: Sunday, July 05, 2009 11:51 PM
To: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] Xen Networking and bonded interfaces on Debia Lenny
El dom, 05-07-2009 a las 19:36 +0000, Joshua Boniface escribió:
> Greetings all. This has been an ongoing issue for me for a few months, and
> I've been trying to get an answer.
>
> My server has two NICs, and I want to set up the following:
>
> NICs (x2) -> bond (mode 5) -> Xen Bridge -> Doms
>
> ...however, trying to configure this doesn't seem to work: network-bridge
> steals eth0 instead of bond0, which breaks the bond AND my networking. The
> result is a "pbond0" interface with no IP, and occasionally a "peth0", also
> with no IP. In either case neither eth0 (or 1) or bond0 exist and as such I
> have no networking at all! If I boot without Xen the bond works fine, so I
> know that's not the problem.
>
> If I reconfigure zend-config.sxp to change netdev=bond0, I still have the
> same issues, though the specific wording of the error (2 pages on a computer
> I can't connect to, and before logon so I can't | less) is different. I've
> also tried messing with the network-bridge script to no avail.
>
> I've read both the manual and the wiki, and while the wiki makes mention of
> using a bond, it doesn't show specifically what is required. I was wondering
> if anyone else could shed some light on the issues. I'm willing to (attempt)
> to write out those 2 pages of errors, if required, though I have a feeling
> this is just a configuration issue.
>
Hello,
Don't use network-bridge to start the bridge. As someone has recommend,
just use network-dummy and configure the bridge in a debian way. This is
my configuration (I'm using bonding, active-backup, and vlan):
auto bond0
iface bond0 inet static
address <ip>
netmask <netmask>
network <network ip>
broadcast <broadcast ip>
gateway <gateway>
# dns-* options are implemented by the resolvconf package, if
installed
dns-nameservers <dns>
slaves eth0 eth3
iface vlan212 inet manual
pre-up /sbin/ifup bond0
vlan-raw-device bond0
iface xen-br212 inet manual
pre-up /sbin/ifup vlan212
bridge_ports vlan212
bridge_fd 0
...
--
Angel L. Mateo Martínez
Sección de Telemática
Área de Tecnologías de la Información _o)
y las Comunicaciones Aplicadas (ATICA) / \\
http://www.um.es/atica _(___V
Tfo: 868887590
Fax: 868888337
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home