WARNING - OLD ARCHIVES

This is an archived copy of the Xen.org mailing list, which we have preserved to ensure that existing links to archives are not broken. The live archive, which contains the latest emails, can be found at http://lists.xen.org/
   
 
 
Xen 
 
Home Products Support Community News
 
   
 

xen-users

RE: [Xen-users] Question on default xen network configs

Hello,

  Thank You for response ;-)

  I work with Debian Etch.

  My point is, why have I to define the IP address in Dom0 if I want to use
the bridge for the DomU? I do not want the Dom0 has also the IP address on
that interface, which receives the traffic for DomU - mainly from security
and configuration effort reasons.

I do not understand why if my bridge is cofigured properly:
wonderland:/# brctl show
bridge name     bridge id               STP enabled     interfaces
eth0            8000.001517708dbc       no              peth0
eth1            8000.001517708dbd       no              peth1
                                                        vif4.0
eth2            8000.000423e45f5a       no              peth2
eth4            8000.000c42072d75       no              peth4
eth5            8000.000c42072d74       no              peth5
eth6            8000.000c42072d77       no              peth6
wonderland:/#

and on eth1 the vif4.0 exists on peth1, why there comes no traffic through?
In the DomU if I ping something, i just get always the "destination host
unreachable" error, the DomU also cannot be pinged from outside...

In iptables I have in forward chain following line

ACCEPT     0    --  anywhere             anywhere            PHYSDEV match
--physdev-in vif4.0

What looks to be also correct for me... 

Also in ifconfig the part relevant for this case looks good I think...

So, where can be the problem? Why have I to define the IP addres in Dom0 to
get it working?

        With regards, Archie

-----Original Message-----
From: Todd Deshane [mailto:deshantm@xxxxxxxxx] 
Sent: Wednesday, August 27, 2008 9:09 PM
To: Artur Linhart - Linux communication
Cc: Phil Winterfield (winterfi); xen-users@xxxxxxxxxxxxxxxxxxx; Asim
Subject: Re: [Xen-users] Question on default xen network configs

Hello,

On Wed, Aug 27, 2008 at 11:46 AM, Artur Linhart - Linux communication
<AL.LINUX@xxxxxxxxxxx> wrote:
> Hello,
>
>        are there any other conditions what to define in xen 3.2.1 in the
> comparison with Xen 3.1.0? My problem is, the bridge is not working till I
> do not define the corresponding eth device and the IP addresses for it in
> /etc/network/interfaces. My DomUs are not accessible through the network
> till I did not define the corresponding eth device in the config file and
> till the Dom0's eth is not accessible throught the IP protocol...
>

It sounds like you are using Ubuntu, the issue here is likely that you have
network manager installed and it doesn't define the network devices in
/etc/network/interfaces.

> In xen 3.1.0 it was much more better - I defined the network bridges
> independently on the vast if the Dom0 "knows" the IP network connected to
> the physical interfaces...
>

This is probably an issue of Xen on <your distro> not being network manager
aware.

> Or do I some mystake and have there some misconfiguration? Re there any
new
> schemes according to the bridges? Can I use the old-style bridging, where
it
> is not necessary to define the corresponding eth device in Dom0 to get
DomU
> working on the interface?
>

You can define your own bridges and that will work fine, but you have
to make sure
all your configurations are updated (i.e. guest configs and if you
specify anything in
the xend config, etc.)

Hope that helps,
Cheers,
Todd

-- 
Todd Deshane
http://todddeshane.net
check out our book: http://runningxen.com

This email was Anti Virus checked by Astaro Security Gateway.
http://www.astaro.com


__________ Informace od NOD32 3394 (20080827) __________

Tato zprava byla proverena antivirovym systemem NOD32.
http://www.nod32.cz



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users