| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] Xen networking problem
Hallo Christian,
> there you could find 'network-bridge', vif-bridge, network-nat and others.
> and inside /etc/xen/xen-config-sxp is defined wich kind of 'network-script'
> you use.
OK. I have enabled network-bridge and vif-bridge. I have tried
network-nat but I don't know how to use it.
Were do I read about these different configurations? Mosti (about all) of the
documentation I have seen so far was about bridging.
> If your using 'network-bridge
> try
> vif = [ 'mac=00:16:3E:10:BE:13', 'ip=192.168.1.200', 'bridge=xenbr0' ]
>
> your domU's nic should be attached to same bridge as eth0/peth0 of dom0 if
> you want bridged networking.
Thanks. The addition of 'bridge=xenbr0' here brought about an
improvement. Now I can ping Dom0 from DomU but not the other way round.
It might be a routing problem. I have two network cards on dom0 and I
cannot see that at this stage xenbr0 plays any role in the routing table
on dom0.
Regards.
Johann
--
Johann Spies Telefoon: 021-808 4036
Informasietegnologie, Universiteit van Stellenbosch
"It is better to trust in the LORD than to put
confidence in man." Psalms 118:8
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home