[Xen-users] xen 3.0 boot problem

[Stephan Böni <boeni@xxxxxx>]

I've installed Xen 3.0-devel on SUSE Linux without any problems.
But when i tryed to boot the system, i've got a funny problem:

qla2300 0000:05:01.0: Found an ISP2312, irq 185, iobase 0xf8812000
qla2300 0000:05:01.0: Configuring PCI space...
qla2300 0000:05:01.0: Configure NVRAM parameters...
qla2300 0000:05:01.0: Verifying loaded RISC code...
qla2300 0000:05:01.0: Waiting for LIP to complete...

until here all works fine, but then:

input: PS/2 Generic Mouse on synaptcs-pt/serio0
qla2300 0000:05:01.0: LIP reset occured (f7f7).
qla2300 0000:05:01.0: LOOP UP detected (2 Gbps).
qla2300 0000:05:01.0: Topology - (F_Port), Host Loop address 0xffff
scsi3 : qla2xxx
qla2300 0000:04:02.0:
  QLogic Fibre Channel HBA Driver: 8.01.00b5-k
  QLogic QLA2340 - 133MHz PCI-X to 2Gb FC, Single Channel
  ISP2312: PCI-X (100 MHz) @ 0000:05:01.0 hdma+, host#=3, 
fw=3.03.15 IPX
Loading kernel/fs/reiserfs/reiserfs.ko
Waiting for device /dev/sda4 to appear: .....not found --- 
exiting to /bin/sh
$

if i use the standard (bigsmp) kernel the normal massages are:

SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB)
SCSI device sda: drive cache: write back
 sda: sda1 sda2 sda3 sda4
....usw.

Well, my qla2300 has the storage attached not a generic mouse.
Of course it isn't possible to boot from this mouse. :-(

What's going wrong here?

Stephan

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users