| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] Failed to Install
Dominik Sennfelder wrote:
Daniel Hulme wrote:
Result
Unable to mount root Filesystem.
title Xen 3.0 / XenLinux 2.6.12
kernel /boot/xen.gz dom0_mem=64000
module /boot/vmlinuz-2.6-xen0 root=/dev/sda1 ro console=tty0
The Problem is that i dont see the detection of the Serveraid adpater
if dom0 ist booting.
so if the Adpater is not recognized the root fs will not be found.
If support for your RAID card or the root filesystem is built as a
module, you will have to either build it into the kernel (see below) or
make an initrd and add it to your GRUB config as a second *module*, not
using the initrd command in GRUB. You create an initrd the usual way,
using 'mkinitrd 2.6.12-xen0'.
ok i have to try that.
Where do i have to configure the Options that the
dom0 Kernel uses the Drivers the actual Kernel uses?
As described in the README, you can cd into the linux-2.6.12-xen0
directory in the source tree and 'make ARCH=xen menuconfig'. With the
options for building a dom0 kernel turned on (which they should be
already) the config is very similar to the standard kernel
configuration.
I tried to configure the Kernel but i miss a lot of Kernel Options.
The problem is that i miss a lot of Configuration Options.
e.g. the only choseable options in SCSI LOW Level Device Drivers are
[*] Serial ATA (SATA)
support
<M> SCSI debugging host simulator
So i can,t build a dom0 domain with the needet Drivers for my system.
Dominik
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home