Re: [Xen-devel] Non-page aligned MMIO BAR error on dom-0 on Xen

Hi Keir,
Thanks for the response. Yes I wanted to do it while the guest is running. I wanted to see if a FLR on dom-0 stops any data traffic from guest OS or not. I also wanted to see whether the device gets operational on guest OS after an interface down (ifconfig down) or reload of the driver in worst-case.

Thanks,
PurnaChandar M

2009/10/15 Keir Fraser <keir.fraser@xxxxxxxxxxxxx>

On 15/10/2009 08:30, "Purna Chandar" <purnachandar.midi@xxxxxxxxxxxxxxxxxx>
wrote:

> But, when I trigger an FLR (function level reset) on the pass-through
> device/function on dom-0 (not on dom-u), I have problems on guest OS. The
> "disabled" bit appears in the lspci output on the device in the guest. The
> driver is not able to do any memory-mapped reads/writes and hence I am not
> able to load the driver. I triggered the FLR using following command:
> # setpci -s 01:00.2 CAP_EXP+8.w=0xa814
> (Before triggering FLR, value at CAP_EXP+8.w is 0x2814. As we have to set last
> bit in PCI Express capability for FLR, value used in above command is 0xa814).

Why would you do that? Do you do it while the guest is running and owns the
device?

-- Keir

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel

<Prev in Thread]

Current Thread

[Next in Thread>

Previous by Date:

Re: [Xen-devel] add the two command to add or delete the usb deviceinstead of do it in QEMU console, James Song

Next by Date:

Re: [Xen-devel] add a description for each guest., James Song

Previous by Thread:

Re: [Xen-devel] Non-page aligned MMIO BAR error on dom-0 on Xen HVM setup, Keir Fraser

Next by Thread:

Re: [Xen-devel] Non-page aligned MMIO BAR error on dom-0 on Xen HVM setup, Konrad Rzeszutek Wilk

Indexes:

[Date] [Thread] [Top] [All Lists]