[XenARM] Supported boards, and project status

[Bachman Kharazmi <bachman.kharazmi@xxxxxxxx>]

Hi,

I have been administrating Xen on i386 for quite a while, but now started to
look into the xen-arm project.

It would be interesting to know whether I could run Xen domUs on a embedded
device. It is a NAS running a debian based OS with the following specification:

MARVELL BOARD: RD-88F6281A LE
U-Boot 1.1.4 (Sep  3 2009 - 10:47:42) Marvell version: 3.4.14
Mapower version: 1.0 (128MB) (2009/09/03)
U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CEE60
Soc: 88F6281 A0 (DDR2)
CPU running @ 1000Mhz L2 running @ 333Mhz
SysClock = 333Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000   size 256MB
DRAM Total size 256MB  16bit width
Flash:  0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:128 MB

If Xen-arm supports this board - what is the difference of the Type 2
hypervisor, compared to Type 1(i386). It would be interesting to run two
paravirtualized domUs, domU-1 and domU-2, with debian based installations (no
real-time requirements) sharing the same embedded hardware. Is this possible?

Thanks,

Bachman

_______________________________________________
Xen-arm mailing list
Xen-arm@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/mailman/listinfo/xen-arm