WARNING - OLD ARCHIVES

This is an archived copy of the Xen.org mailing list, which we have preserved to ensure that existing links to archives are not broken. The live archive, which contains the latest emails, can be found at http://lists.xen.org/
   
 
 
Xen 
 
Home Products Support Community News
 
   
 

xen-users

[Xen-users] 3.4.2 domU networking fails to recover after glitch

To: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: [Xen-users] 3.4.2 domU networking fails to recover after glitch
From: Tony Lill <ajlill@xxxxxxxxxxxxxxxxxxx>
Date: Thu, 03 Dec 2009 11:24:26 -0500
Delivery-date: Thu, 03 Dec 2009 08:25:18 -0800
Envelope-to: www-data@xxxxxxxxxxxxxxxxxxx
List-help: <mailto:xen-users-request@lists.xensource.com?subject=help>
List-id: Xen user discussion <xen-users.lists.xensource.com>
List-post: <mailto:xen-users@lists.xensource.com>
List-subscribe: <http://lists.xensource.com/mailman/listinfo/xen-users>, <mailto:xen-users-request@lists.xensource.com?subject=subscribe>
List-unsubscribe: <http://lists.xensource.com/mailman/listinfo/xen-users>, <mailto:xen-users-request@lists.xensource.com?subject=unsubscribe>
Sender: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
User-agent: Gnus/5.1008 (Gnus v5.10.8) XEmacs/21.4.22 (linux)
A couple of times yesterday, my network hiccuped (something funky on
the switch, a couple of other hosts reported the same thing). While
the dom0 handled it fine, I could not communicate to any of my
domUs. using tcpdump on both eth2 and peth2, I could see them send
packets out, but could not see any of the response packets.

These are the messages that I get around the hiccup

Dec  2 10:52:34 xen kernel: skge peth2: Link is down.
Dec  2 10:52:34 xen kernel: eth2: port 1(peth2) entering disabled state
Dec  2 10:52:36 xen kernel: skge peth2: Link is up at 1000 Mbps, full duplex, 
flow control tx and rx
Dec  2 10:52:36 xen kernel: eth2: port 1(peth2) entering learning state
Dec  2 10:52:36 xen kernel: eth2: topology change detected, propagating
Dec  2 10:52:36 xen kernel: eth2: port 1(peth2) entering forwarding state

I haven't had time to do any serious debugging, but I'm hoping
someones has seen similar problems.

--
Tony Lill,                         Tony.Lill@xxxxxxxxxxxxxxxxxxx
President, A. J. Lill Consultants                 (519) 650 0660
539 Grand Valley Dr., Cambridge, Ont. N3H 2S2     (519) 241 2461
--------------- http://www.ajlc.waterloo.on.ca/ ----------------



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

<Prev in Thread] Current Thread [Next in Thread>