[Xen-users] missing ethernet device

[Brock Palen <brockp@xxxxxxxxx>]

I have two new dell poweredge SC 440's,   These were the machines  
that were to work as a pair of xen hosts.
They come with a integrated Broadcom 57XX series chip.  A regular  
kernel (generated with gentoo's genkernel) and the nic uses the tg3  
driver as expected.
When it comes to xen though i can not get the device to appear at  
all,  I even plugged in a differnt NIC i had in a pci slot and it  
worked just fine with the xen kernel, but the boradcom does not  
appear.  I see no errors.  the tg3 driver is compiled into the kernel.
Here is the output of lspci -v  for the boradcom

04:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5754  
Gigabit Ethernet PCI Express (rev 02)
        Subsystem: Dell Unknown device 01df
        Flags: bus master, fast devsel, latency 0, IRQ 10
        Memory at efcf0000 (64-bit, non-prefetchable) [size=64K]
        Capabilities: [48] Power Management version 3
        Capabilities: [50] Vital Product Data
        Capabilities: [58] Vendor Specific Information
        Capabilities: [e8] Message Signalled Interrupts: 64bit+  
Queue=0/0 Enable-
        Capabilities: [d0] Express Endpoint IRQ 0

What are obvious things i should look for that i would be missing  
from my config?  Or anything that xen would conflict with?  I am  
using the xen-3.0.3 downloaded just yesterday.
Brock Palen
Center for Advanced Computing
brockp@xxxxxxxxx
(734)936-1985



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users