|  |  | 
  
    |  |  | 
 
  |   |  | 
  
    |  |  | 
  
    |  |  | 
  
    |   xen-users
[Xen-users] xen 3.0.3 and LVM 
| IBM xseries 306m
Slackware 10.2
2GB of RAM
3.2Ghz Xeon
Scsi drive:WDC WD1600JS-23M Rev: 03.0
I installed xen 3.0.3 and specified a dom0 and a domU kernel in the Makefile.
Everything built and installed fine and I can boot the system but when I try to
run vgscan I get the error: "vgscan -- LVM driver/module not loaded?". So I
tried to load the module, 'modprobe dm_mod' and it says it is not found. I
checked the kernel using a 'make menuconfig' and found the device mapper module
statically compiled into the kernel.
So the module is compiled into the kernel but I have no lvm support and the only
module I can see that is loaded is agpgart, that is the only module that loads.
Has anybody seen this and know how to get around it? Do I need an initrd to
make xen3.0.3 to work?
Thanks for any advice,
Jon
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
 | 
 
| <Prev in Thread] | Current Thread | [Next in Thread> |  | 
[Xen-users] xen 3.0.3 and LVM,
jonr <=
 |  |  | 
  
    |  |  |