| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] FC4 + Xen 2.0.6 eth0 failed
On 8/24/05, Pavel Kozubenko <pavelyk@xxxxxxxxxxx> wrote:
While Linux boots up, I can see it trying to
initialize eth0. I assume I have to have dom0 instead. After this failure, of
course, the xend fails and the like. Yes, I did try to bring it up manually. It
say no interface at all.
Thank you,
----- Original Message -----
Sent: Tuesday, August 23, 2005 12:18
PM
Subject: Re: [Xen-users] FC4 + Xen
2.0.6
eth0 failed
On 8/23/05, Pavel
Kozubenko <pavelyk@xxxxxxxxxxx> wrote:
I
am new to XEN. Just installed xen on my fedora core 4 following
the
instructions given by Red Hat ( using 'yum'). I was able to boot to X
window
but my eth0 is not available nor I can see my ethernet interfaces
anymore. I
use DELL Dimension 2100 with built-in LAN interface and also
have one in one
of PCI slots. None of them visible. ANy idea
why it might happen?
Thanks,
Pavel
Kozubenko
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
I
hope you mean this is on dom0. Have you tried to bring up you nic
manually?
Further question here for others - I am running
Xen 2.0.6 on , Ubuntu 5.4 as dom0. Networking is fine. Running lspci shows me
my nic (Broadcom), but lsmod does not show module for my nic. What would be
happening behind.
--
benjamin
rualthanzauva
What message did you
get when you tried to bring up the interface via the script
(/etc/init.d/network start) or using ifconfig ?
--
benjamin rualthanzauva
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home