| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] Re: Problems building a xen0 kernel on Suse 9.3
Chris Epicier <seuchato@xxxxxxxx> writes:
> While playing with my xen setup I noticed the
> following:
> Under default kernel, I could set the nics to a config
> of my taste, ie: eth-int (internal) and eth-ext
> (exzternal). Booting into xen, yast came up mentioning
> ot had found new hardware: the nics, but in reversed
> order! So I could not ping or remote ssh into the
> xenbox. I had to name the nics eth0 and eth1, other
> did not work. like this, it survives a reboot too.
Hmm, by default the nics are identified by mac address, so the module
load order shouldn't matter ...
You can also explicitly add the nic modules to INITRD_MODULES (in
/etc/sysconfig/kernel), then rerun mkinitrd. That should make sure
the modules loaded by the initrd in the order specified, thus giving
fixed names to the interfaces.
Gerd
--
-mm seems unusually stable at present.
-- akpm about 2.6.12-rc3-mm3
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home