|  |  | 
  
    |  |  | 
 
  |   |  | 
  
    |  |  | 
  
    |  |  | 
  
    |   xen-users
Re: [Xen-users] 3ware controller monitoring 
| 
Hi again,
 The underlying system has a 3ware ATA RAID controller running a RAID1 raid. 
I now would like to monitor the status of the raid, so I have to run a 
certain 3ware_cli command in dom0. This command tries to access 
/proc/scsi/3w-xxxx but does not find it (it's not there). Is there anything 
I can do to help it?
 
Are you sure that your driver for the 3ware card is loaded ?
 
I thought that if I can access the drive (with the root filesystem on it, for 
example) through /dev/sda, I can be pretty sure the driver is loaded. 
Furthermore, the following is true:
> grep 3W /boot/config-2.6.10-xen0
CONFIG_BLK_DEV_3W_XXXX_RAID=y
# CONFIG_SCSI_3W_9XXX is not set
As you can see, the domain 0 kernel is configured for the block device.
Also, running dmesg in dom0 shows:
3ware Storage Controller device driver for Linux v1.26.02.000.
PCI: Obtained IRQ 18 for device 0000:02:03.0
scsi0 : 3ware Storage Controller
3w-xxxx: scsi0: Found a 3ware Storage Controller at 0xd000, IRQ: 18.
  Vendor: 3ware     Model: Logical Disk 0    Rev: 1.2
  Type:   Direct-Access                      ANSI SCSI revision: 00
So I think it must be there. Or am I wrong?
This is all a little new for me.
Best regards,
Carsten
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
 | 
 |  | 
  
    |  |  |