[Xen-ia64-devel] Could you tell me howto run xen on ski?

[Matsumoto <n_matumoto@xxxxxxxxxxxxxxxx>]

Hi, all

I am interested in running ski for Xen development.

First, I tried to run native vmlinux(which is complied with CONFIG_HP_SIM
and so on).

But I have not been able to boot vmlinux.

# xski bootloader vmlinux root=/dev/sda1 simscsi=/nue/var/ski-disks/sda
simeth=eth0

The result is :

==================================================

loading vmlinux...

starting kernel...

Linux version 2.6.12 (root@xxxxxxxxxxxxxxxxxxxxxxxxxxx) (gcc version 3.4.4

20050721 (Red Hat 3.4.4-2)) #1 SMP Fri Dec 2 13:43:29 JST 2005 EFI v1.00 by
Hewlett-Packard: SALsystab=0x10a0b8

warning: unable to switch EFI into virtual mode (status=9223372036854775811)
No I/O port range found in EFI memory map, falling back to AR.KR0 I/O port
base = 0xffffc000000

efi.trim_top: ignoring 2048KB of memory at 0x200000 due to granule hole at
0x8000000

warning: skipping physical page 0

SAL 0.1: Hewlett-Packard HP-simulator version 0.0 No logical to physical
processor mapping available

get_max_cacheline_size: ia64_pal_cache_summary() failed (status=-1)
PAL_VM_PAGE_SIZE failed with status=-1;defaulting to architected purge
page-sizes.

cpu_init: PAL VM summary failed, assuming 18 RID bits MCA related
initialization done Virtual mem_map starts at 0xa0007fffff1e4000 Built 1
zonelists Kernel command line: root=/dev/sda1 simscsi=/root/ski/xenia64.img
simeth=eth0 PID hash table entries: 1024 (order: 10, 32768 bytes) :-<
"Processing stops here. "

==================================================

Did I mistake anything?

Please tell me howto run xen on ski if anyone use ski.

Thanks,

Nakato



_______________________________________________
Xen-ia64-devel mailing list
Xen-ia64-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-ia64-devel