On Thu, Nov 11, 2010 at 12:58:09PM -0500, Konrad Rzeszutek Wilk wrote:
> On Thu, Nov 11, 2010 at 05:38:50PM +0000, Mark Adams wrote:
> > On Thu, Nov 11, 2010 at 11:53:40AM -0500, Konrad Rzeszutek Wilk wrote:
> > > On Thu, Nov 11, 2010 at 10:24:17AM +0000, Mark Adams wrote:
> > > > Hi All,
> > > >
> > > > Running xen 4.0.1-rc6, debian squeeze 2.6.32-21.
> > > >
> > > > In a voip setup, where I have forwarded the onboard NIC interfaces
> > > > through to domU using the following grub config:
> > > >
> > > > module /vmlinuz-2.6.32-5-xen-amd64 placeholder
> > > > root=UUID=25c3ac79-6850-498d-afcf-ea42970e94fd ro quiet
> > > > xen-pciback.permissive xen-pciback.hide=(02:00.0)(03:00.0)
> > > > pci=resource_alignment=02:00.0;03:00.0
> > > >
> > > > I'm having a serious issue where the raid card goes offline after an
> > > > indefinate period of time. Sometimes runs fine for a week, other times 1
> > > > day before I get "offline device" errors. Rebooting the machine fixes it
> > > > straight away, and everything is back online.
> > > >
> > > > What in the Xen pciback is causing the raid card to go offline? The
> > > > only devices hidden are the 2 onboard NIC's.
> > >
> > > You need to give more details. Is the RAID card a 3Ware? An LSI? Do you
> > > run with an IOMMU? When the RAID card goes offline, do you see a stop of
> > > IRQs going to the device? Are the IRQs for the RAID card sent to all of
> > > your
> > > CPUs or just a specific one? Are you pinning your guests to specific CPUs?
> > > Does the issue disappear if you don't passthrough the NIC interfaces? If
> > > so have
> > > you run this setup for "a week" to make sure?
> >
> > It is an Areca 1220. I can't see anything when the device goes offline
> > apart from
> >
> > [77324.264270] sd 0:0:0:1: rejecting I/O to offline device
> > [77334.005854] sd 0:0:0:0: rejecting I/O to offline device
>
> That is it? No other details from the driver? Did you poke at the driver
> (modinfo)
> to see if there are any options to increase its verbosity.
I can't do anything once its happened, everything is offline so I have
no utils...
>
> >
> > Unfortunately nothing get's logged because there is nothing to write to
> > anymore. I'm not sure how I can see the IRQs otherwise. There is no
>
> cat /proc/interrupts
>
> > pinning being done at all, and the machine was running for a few months
> > OK before the pciback was added.
>
> Ok, what about your NICs? Are they on-board? Are they sharing the IRQ
> with the card? You should be able to see this by looking at /proc/interrupts.
> Which NICs are they? lspci can you help you there. As of matter of fact, run
> lspci -vvv and send that.
It is the onboard nics, they are Intel 82574L. I can see the arcmsr
line, but not anything for the NICS (because they are hidden?)
39: 1126249 0 0 0 0 0 0
0 xen-pirq-ioapic-level arcmsr
Nothing else is on 1126249
see lspci.txt attached.
> >
> > Is my kernel module line correct above? are the xen-pciback.permissive
> > and resource_alignment options required? Also I am passing through the
>
> Not always. The resource_alignment only if the BARs (look at lspci output) are
> not page-aligned. If you have no idea what I am talking about then the answer
> is yes.
>
> > onboard NIC's - is this something that should be avoided or is it ok to
> > do?
>
> It is fine. That is the first thing I test..
>
> >
> > > >
> > > > I know that this issue is with Xen, as I had this running on a different
> > > > server (same xen setup) and it had the same issues, which I initially
> > > > thought were to do with the raid card.
> > >
> > > So you never ran this setup on this kernel (2.6.32-5) without the Xen
> > > hypervisor?
> >
> > no, its always had the hypervisor - but it was running ok before the
> > pciback options were added. This week, it's seemed to happen
> > approximately every 24 hours.
>
> When this hang occurs, can you do 'xm debug-key Q', 'xm debug-key i', 'xm
> debug-key z'.
> Then run 'xm dmesg' and provide that to me?
I can try this, but It probably won't work as the device is will not be
readable.
>
> Is your boot disk on the same disk as the RAID?
There are 2 raids, a Raid1 for the OS (/boot / /var /tmp /usr) and a
raid5 for VM's - They both dissapear at the same time so it appears the
card is dissapearing..
lspci.txt
Description: Text document
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home